User's Manual

network provider.
With the UIM card, which stores many parameters required for communications, you can use the various
functions of the phone and store personal information, including PIN (Personal Identification Number),
phonebook, short messages and other additional system services. Please handle the UIM card with care, twisting
or pressing it may cause damage. If it is lost, please contact your network operator immediately for help.
(Note): The UIM card shall be placed beyond the range of children.
Installing your UIM card
Switch off your phone before installing the UIM card. To install the UIM card at the back of the phone, follow
the steps below:
1. Turn the phone over to the back, open the back cover and remove the battery by pushing up the battery.
With the metal contacts of the UIM card downward and the unfilled corner against the one within the groove,
insert the card into the groove from top to bottom.
2. After the card is inserted into the groove, insert the bottom of the battery into the fastening groove of the
phone, and push it down till the metal contacts of the battery completely meet with battery connector in the
phone, then push the cover back.
PIN code
It is Personal Identification Number used to access the UIM card. If PIN code protection function has been
enabled, the screen will indicate “Enter PIN:” when switched on. You must input correct PIN code at this time
prior to using the phone.
You can get the PIN code while obtaining the UIM card from your network operator. Usually the PIN code is 4
digits. During input of the PIN code, the screen will display “*” to substitute the input content to ensure
confidentiality.
<Warning>: If you input wrong PIN code for three consecutive times, the UIM card will be locked. Please contact the network
operator immediately for assistance of decoding. Attempt to decode the card by yourself may possibly cause the UIM card to fail
permanently.
Charging your battery
 The battery used in the phone is rechargeable. New battery must be fully charged before it is used for
the first time. Only after several times of charging and discharging can the battery’s efficiency made the
best of.
 To ensure the battery in optimal state, we recommend you discharge the battery fully at least once every
month by consuming the power until the phone is switched off automatically.
 During the course of charging, it is normal to find the battery and the phone slightly heat-up. The phone
will automatically protect itself when battery temperature rises so as to control temperature variation.
 The handset will give off alert as the battery is running out. When the power has run out the handset will
be switched off automatically.
Page 8