Instructions / Assembly

TOOLS REQUIRED

CAUTION

Wire

strippers

Ladder

Safety

glasses

Electrical

tape

Phillips

screwdriver

PliersFlat blade

screwdriver

• Inspect the wire insulation for any cuts,

abrasions, or exposed copper that may have

resulted during shipping. If there is a defect in

the wire, do not attempt installation.

• Before starting installation of this ﬁxture or

removal of a previous ﬁxture, disconnect the

power by turning oﬀ the circuit breaker or by

removing the fuse at the fuse box.

Fixture Iron Rack Bracket Screws

Decorative

Screws

Mounting Unit

Mounting

Screws

Wire Nuts

*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE

Assembly Instructions

STEP 1

Attach the iron rack and brackt onto ﬁxture using decorative screws and screws.

STEP 3

Install stems based on the desired length

of the item, adding canopy once ﬁnished.

HARDWARE INCLUDED

INSTALLATION

Ball Nuts

Stems

Canopy

STEP 2

Unscrew the ball nuts from the mounting unit.

Use the mounting screws to attach the

mounting unit to the junction box.

PAGE 1
Assembly Instructions CAUTION • Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have resulted during shipping. If there is a defect in the wire, do not attempt installation. • Before starting installation of this ﬁxture or removal of a previous ﬁxture, disconnect the power by turning oﬀ the circuit breaker or by removing the fuse at the fuse box.
PAGE 2
Assembly Instructions INSTALLATION Connect Clear, Brown, Gold or Black Parallel Wire without tracer (round & smooth) or Black Fixture Wire to: STEP 4 Make the electrical connection from the junction box to the fixture. Connect the ground wire to the mounting unit using the preinstalled green ground screw. Then, connect the positive, negative and ground wires with the supplied wire nuts. Secure with electrical tape. Black or Red Supply Wire or Insulated Wire (other than green) with copper conductor.