Instructions / Assembly

Bulbs
(not included)
*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE
EXPLODED PARTS INSTALLATION
STEP 3
STEP 2
Use the mounting screws to attach the
mounting unit to the junction box
(not included).
HARDWARE INCLUDED
Fixture
Mounting Unit
Fixture Mounting Unit Mounting Screws
Mounting Screws
Wire Nuts
Wire Nuts
Chain
Chain
Canopy
Canopy
Screw Collar Ring
Screw Collar Ring
Junction Box
(not included)
1. Choose the length of the chain
you need (Open the chain using a
phillips screwdriver (not included)
and pliers (not included). )
2. Attach the end of the chain to the
loop on the fixture.
STEP 1
1. Pass the chain and the branch wires through
the screw collar ring and canopy.
2. Attach the end of the chain to the
mounting unit.
3. Feed the branch wires through the pipe nipple
on the mounting unit.
*junction box
(not included)
Wire
strippers
Ladder
Safety
glasses
Electrical
tape
Phillips
screwdriver
Flat blade
screwdriver
Pliers
CAUTION
◆ Inspect the wire insulation for any cuts,
abrasions, or exposed copper that may have
resulted during shipping. If there is a defect
in the wire, do not attempt installation.
◆ Before starting installation of this fixture or
removal of a previous fixture, disconnect the
power by turning off the circuit breaker or by
removing the fuse at the fuse box.
If you need further assistance, please contact us by Email: [e-mail]
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED
@