HU6677B_Instruction_Sheet

2.3 Clear the Energy
Step 1: In the normal display interface, long press of the
button until the LCD shows the interface of Figure 2, then
release the button, short press of the button again will
switch to the interface to Figure 9, it indicates that this
state is the clearing energy setting state.
Step 2: Longer press of the button until the data has been
cleared and exit the setting status, restore the normal
display interface.
2.4 Clear the capacity
Step 1: In the normal display interface, long press of the
button until the LCD shows the interface of Figure 2, then
release the button, short press of the button again switch
to the interface to Figure 10, it indicates that this state is
the clearing capacity setting state.
Step 2: Longer press the button until the data has been
cleared and exit the setting status, restore the normal
display interface.
2.5 Clear the running time
Step 1: In the normal display interface, long press of the
button until the LCD shows the interface of Figure 2, then
release the button, short press of the button again to
switch to the interface to Figure 11, it indicates that this
state is the clearing running time setting state.
Step 2: Longer press of the button until the data has been
cleared and exit the setting status, restore the normal
display interface.
2.6 Working mode
This meter has two modes: normal display mode and
dormant mode. In normal display mode, short press the
button to enter the dormant mode, in order to reduce
the whole machine power consumption, the backlight
and LCD display will be turned off in dormant mode. In
dormant mode, short press the button will switch to the
normal display mode.
Note: The meter will stop all measurement functions in
dormant mode, so please do not switch to dormant mode
if normal measurement is performed.
3. PLEASE BE AWARE:
3.1 This module is suitable for indoor use only, it is not
water proof, so please do not use outdoors.
3.2 Applied load should not exceed the rated voltage,
current.
3.3 Please make sure it is wired correctly, if not followed
correctly it can permanently damage the unit.
**Warranty not given if this is the case.**
4. OTHER SPECIFICATION
4.1 LCD full display figure
4.2 Power consumption
Normal working state: 0.03-1.2 W
Sleeping state: 0.5mW-0.5W
The power consumption is related to the test voltage
value, the higher the voltage the greater the power
consumption.
4.3 Working temperature
-20’C ~ +60’C
Figure 9: Clear the energy interface
Figure 10: Clear the capacity interface
Figure 11: Clear the running time interface
Figure 18: LCD full display figure