/2 HP OIL FREE AIR COMPRESSOR MODEL: HP00P001S1 INSTRUCTION MANUAL Heavy duty rubber feet for rough terrain on job sites
IMPORTANT INFORMATION HULK LIMITED WARRANTY FOR THIS 1/2 HP AIR COMPRESSOR 2 Year limited warranty on pumps 1 Year limited warranty on parts & labor PROOF OF PURCHASE Please keep your dated proof of purchase for warranty and servicing purposes. REPLACEMENT PARTS Replacement parts for this tool are available at our authorized HULK service centers across USA. For servicing, contact or return to the retailer where you purchased your product along with your proof of purchase.
IMPORTANT SAFETY INSTRUCTIONS RISK OF EXPLOSION OR FIRE WHAT CAN HAPPEN HOW TO PREVENT It is normal for electrical contacts within the motor and pressure switch to spark. Always operate the compressor in a well ventilated area free of combustible materials, gasoline or solvent vapors. If spraying flammable materials, locate the compressor at least 20 feet away from the spray area. An additional length of hose may be required. Store flammable materials in a secure location away from the compressor.
SPECIFICATIONS & ELECTRICAL INFORMATION SPECIFICATIONS Model ................................................................................................................................................................................HP00P001S1 Voltage ............................................................................................................................................................................................110V Horsepower ...................................................
OPERATION CONTROLS A AIR COMPRESSOR PUMP. To compress air, the piston moves up and down in the cylinder. On the downstroke, air is drawn in through the intake valves. The exhaust valves remain closed. On the upstroke of the piston, air is compressed. The intake valves close and compressed air is forced out through the exhaust valves. CHECK VALVE (A) FIG.3. When the air compressor is operating, the check valve is “open”, allowing compressed air to enter the air tank.
BREAK-IN PROCEDURES & OPERATION LOCATION OF THE AIR COMPRESSOR Your compressor comes almost completely assembled, the air filter must be installed. Operate the air compressor in a dry, clean, cool, well ventilated area. The air compressor pump and case are designed to allow for proper cooling. Clean or blow off dust or dirt that collects on the air compressor. A clean air compressor runs cooler and provides longer service.
MAINTENANCE & STORAGE MAINTENANCE Before doing any maintenance or adjustments to your air compressor, the following safety precautions should be taken: - Disconnect electrical power. - Drain air tank of pressure. Daily or before each use 1. Drain condensation from tank. 2. Check for any unusual noise or vibration. 3. Be sure all nuts and bolts are tight. Monthly 1. Inspect air system for leaks by applying soapy water to all joints. Tighten those joints if leakage is observed.
PARTS DIAGRAM MODEL: HP00P001S1 25 26 22 24 22 27 52 8 28 23 29 32
PARTS LIST MODEL: HP00P001S1 Qty No. Part Number SHROUD 1 30 FA40710000 BOLT 4 31 SW30504130 SPRING WASHER 1 MOTOR COVER 1 No.
937-540-1157
