user manual

ManualsBrandsHuman Touch ManualsAutomobile AccessoriesAutomobile Accessories HT-5020

1. Power off the chair, then unplug it.

2. Remove all pads from the chair (Fig.1).

3. Using a 5-mm Allen wrench, remove the two Allen screws/washers that secure the armrest to the seat frame (Fig.2).

4. Lift up on the armrest to remove it from the chair (Fig.2).

REMOVING THE ARMREST

REPLACING THE ARMREST

(Fig.1)

HT-5020

Tools Required: 5-mm Allen wrench, flat-head screwdriver. NOTE: SAVE ALL PARTS FOR USE DURING REASSEMBLY.

November 22, 2010

It is imperative that Human Touch

products are repaired in a manner that ensures product safety and regulatory compliance and that is fully consistent with the practices used

during the manufacturing process. Therefore, Human Touch requires that all product repairs are performed using only factory-new parts and in accordance with these repair

instructions. Failure to adhere to these instructions voids the product warranty and releases Human Touch from all liability for injury or product damage resulting from the repair.

SERVICE LEVEL: 3

Armrest

5-mm Allen wrench

Allen bolt

Washer

(Fig.2)

Summary of content (2 pages)

PAGE 1
November 22, 2010 HT-5020 REPLACING THE ARMREST It is imperative that Human Touch® products are repaired in a manner that ensures product safety and regulatory compliance and that is fully consistent with the practices used during the manufacturing process. Therefore, Human Touch requires that all product repairs are performed using only factory-new parts and in accordance with these repair instructions.
PAGE 2
INSTALLING THE NEW ARMREST 1. 2. 3. 4. Align the armrest post with the corresponding fittings on the chair frame (Fig.3). Align the metal shift lever rod with the plastic bushing on the armrest, then insert the rod into the bushing as you push the armrest downward into position (Fig.4). Replace the two Allen screws/washers you removed earlier to secure the armrest to the chair. Plug in the chair, power it on, then verify that the recline lever is working properly.