User Guide

REPLACING THE POWER PANEL
HT-2620/iJOY-300
REMOVING THE POWER PANEL
1. Turn the power switch on the power panel to OFF and unplug the chair.
2. Tip the chair gently forward, until the backrest is resting on the floor (Fig.1).
3. Using a Phillips-head screwdriver, remove the four screws from the inside of the power panel (Fig.2).
4. Detach the power panel from the chair to expose the connectors (Fig.3).
5. Disconnect the two sets of connectors (Fig.3).
6. Using a flat-head screwdriver, remove the screw that secures the green grounding wire to the chair (Fig.3).
7. Remove the power panel from the chair.
Tools Required: Phillips-head screwdriver, flat-head screwdriver.
SAVE ALL REMOVED PARTS FOR USE DURING REASSEMBLY
Power panel
Power panel (inside)
(Fig.1)
(Fig.2)
Power panel
Connectors
Green grounding wire
(Fig.3)
Power panel (outside)
1
January 03, 2011
It is imperative that Human Touch
®
products are repaired in a manner that ensures product safety and regulatory compliance and that is fully consistent with the practices used
during the manufacturing process. Therefore, Human Touch requires that all product repairs are performed using only factory-new parts and in accordance with these repair
instructions. Failure to adhere to these instructions voids the product warranty and releases Human Touch from all liability for injury or product damage resulting from the repair.
SERVICE LEVEL: 2