Wheelchair User Manual

ManualsBrandsHuman Touch ManualsWheelchairHT-275

REMOVING THE SEAT CUSHION

1. Raise the footrest deployment handle to deploy the footrest (Fig.1).

2. Power off the chair, then unplug it.

3. Use your fingers to pop off the right-hand side panel (Fig.2).

4. Using a Phillips-head screwdriver, remove the screw from the underside of the right-hand armrest screw (Fig.3).

5. From underneath the chair, use a 16mm open wrench or socket wrench to remove the armrest bolt (Fig.4).

Tools Required: Phillips-head screwdriver, small flat-head screwdriver, 16mm open wrench or socket wrench, two people.

NOTE: SAVE ALL REMOVED PARTS FOR USE DURING REASSEMBLY

REPLACING THE SEAT CUSHION

April 25, 2012

It is imperative that Human Touch

products are repaired in a manner that ensures product safety and regulatory compliance and that is fully consistent with the practices used

during the manufacturing process. Therefore, Human Touch requires that all product repairs are performed using only factory-new parts and in accordance with these repair

instructions. Failure to adhere to these instructions voids the product warranty and releases Human Touch from all liability for injury or product damage resulting from the repair.

SERVICE LEVEL: 3

HT-270 / HT-275

(Fig.1)

(Fig.2) (Fig.3) (Fig.4)

Right-hand side panel

Seat cushion

Summary of content (3 pages)

PAGE 1
April 25, 2012 HT-270 / HT-275 REPLACING THE SEAT CUSHION It is imperative that Human Touch® products are repaired in a manner that ensures product safety and regulatory compliance and that is fully consistent with the practices used during the manufacturing process. Therefore, Human Touch requires that all product repairs are performed using only factory-new parts and in accordance with these repair instructions.
PAGE 2
6. Carefully remove the right-hand armrest from the chair. 7. Place a box or other sturdy object underneath the footrest, to hold it in place (Fig.5). 8. Locate the footrest actuator underneath the footrest, then use a flat-head screwdriver to remove the “C” clip and pin that secures the front end of the actuator to the footrest (Fig.6). 9. Repeat steps 3 – 5 to remove the left-hand armrest. 10.
PAGE 3
INSTALLING THE NEW SEAT CUSHION 1. Place the seat cushion into position on the chair. 2. From the front of the chair, slide the armrest backward into place. The tab on the bottom of the armrest slides into a slot on the chair. 3. Replace the screw on the underside of the armrest. 4. Align the left-hand armrest bolt hole with the corresponding hole in the chair frame, then replace the bolt to secure it. 5. Press the side panel into place. 6.