User Guide

REMOVING THE FOOT AND CALF MASSAGER

1. Lift the foot and calf massager up, then place a box or other sturdy object beneath it

for support.

2. Locate the air pump on the bottom of the chair, then remove the six sets of screws/washers

that secure the pump to the chair (Fig. 1).

3. Locate the connector box on the bottom left side of the chair, near the foot and calf

massager (Fig.2).

4. Using a Phillips-head screwdriver, remove the two screws that secure the connector box cover,

remove the cover, then disconnect the red connector.

5. Cut any zip ties that secure the cable that runs from the connector box to the foot and calf

massager, to free the cable from the chair base.

6. Remove the box or other sturdy object that is supporting the foot and calf massager,

allowing the massager to drop down to a vertical position.

7. Standing in front of the foot and calf massager, detach the upholstered flap that covers the

massager frame (Fig.3).

NOTE: It is helpful to flip the upholstered flap up onto the seat cushion and place an object on

top of it to hold it out of the way.

Tools Required: Nail clipper or other instrument suitable for cutting zip ties, Phillips-head screwdriver, flat-head

screwdriver, vice grip, small hammer.

NOTE: SAVE ALL SCREWS FOR USE DURING REASSEMBLY.

REPLACING THE FOOT AND CALF MASSAGER

HT-7120

March 14, 2012

(Fig.3)

(Fig.2)

Screw/washer

Air pump

(Fig.1)

To ensure that Human Touch

products are repaired in a manner that is fully consistent with the practices used during the manufacturing process, Human Touch requires that all

product repairs are performed using only factory-new parts and in accordance with these product repair instructions.

SERVICE LEVEL: 3

PAGE 1
March 14, 2012 REPLACING THE FOOT AND CALF MASSAGER HT-7120 To ensure that Human Touch® products are repaired in a manner that is fully consistent with the practices used during the manufacturing process, Human Touch requires that all product repairs are performed using only factory-new parts and in accordance with these product repair instructions.
PAGE 2
8. Using a Phillips-head screwdriver, remove the two screws from the two brackets on the massager frame, then remove the brackets (Fig.4). 9. Locate Pin A, insert a flat-head screwdriver between the pin head and the bracket, then tap the screwdriver handle to dislodge the pin from the bracket approximately 1/2 inch (Fig.4). NOTE: If the pin is stuck in the bracket, tap the pin with a hammer on the exposed area between the two sides of the mounting bracket to loosen it (Fig.4). 10.
PAGE 3
INSTALLING THE NEW FOOT AND CALF MASSAGER 1. Place the new foot and calf massager into position, then insert pin A just far enough into the left side of bracket A to hold it in place. 2. Line up the actuator bracket with the mounting point on Bracket A, then push the pin through the bracket as far as it will go by hand. 3. Line up the left side of the massager with Bracket B, then insert Pin B through the bracket as far as it will go by hand. 4.