Indoor Furnishings User Manual

ManualsBrandsHuman Touch ManualsIndoor FurnishingHuman Touch Massage Chairs





 



 

 







 















































































Summary of content (3 pages)

PAGE 1
July 29, 2009 REPLACING THE BACKREST COVER HT-5040 To ensure that Human Touch® products are repaired in a manner that is fully consistent with the practices used during the manufacturing process, Human Touch requires that all product repairs are performed using only factory-new parts and in accordance with these product repair instructions. SERVICE LEVEL: 2 Tools Required: 4 mm (5/32") "") Allen key, Phillips-head screwdriver, flat-head screwdriver.
PAGE 2
6. Tip the backrest cover backward then lay it carefully down on the floor behind the chair. 7. Disconnect the connector at the base of the backrest (Fig.4). 8. Using a flat-head screwdriver, remove the screw that secures the yellow/ green ground wire to the chair frame. Ground wire screw 9. Remove the backrest cover. Ground wire Connector Backrest cover (Fig.
PAGE 3
INSTALLING THE NEW BACKREST COVER 1. Place the new backrest cover on the floor behind the chair, as shown (Fig.5). Ground wire screw 2. Connect the large connector. 3. Insert the ground wire screw through the loop on the end of the ground wire, place the screw in the corresponding screw hole on the chair frame, then secure the screw using a flat-head screwdriver (Fig.5). 3.