User's Manual

ManualsBrandsHuman Touch ManualsWheelchairHuman Touch Human Touch Wheelchair HT-135

REMOVING THE BACKREST COVER

1. Power off the chair and unplug it.

2. Push down on the backrest release lever, then fold the backrest forward

onto the chair seat (Fig.1).

3. Using a Phillips-head screwdriver, remove the four screws that secure

the remote control bracket to the backrest cover (Fig.2).

4. Pull the remote control cables through the backrest cover, then disconnect the cables.

5. Using a 4 mm (5/32") Allen key, remove the four backrest cover screws (Fig.3).

Tools Required: 4 mm (5/32") Allen key, Phillips-head screwdriver.

SAVE ALL REMOVED PARTS FOR USE DURING REASSEMBLY

Backrest release lever

Backrest cover

(Fig.1)

(Fig.2)

(Fig.3)

REPLACING THE BACKREST COVER

HT-135

It is imperative that Human Touch

products are repaired in a manner that ensures product safety and regulatory compliance and that is fully consistent with the practices used

during the manufacturing process. Therefore, Human Touch requires that all product repairs are performed using only factory-new parts and in accordance with these repair

instructions. Failure to adhere to these instructions voids the product warranty and releases Human Touch from all liability for injury or product damage resulting from the repair.

SERVICE LEVEL: 2

July 30, 2013

Summary of content (3 pages)

PAGE 1
July 30, 2013 HT-135 REPLACING THE BACKREST COVER It is imperative that Human Touch® products are repaired in a manner that ensures product safety and regulatory compliance and that is fully consistent with the practices used during the manufacturing process. Therefore, Human Touch requires that all product repairs are performed using only factory-new parts and in accordance with these repair instructions.
PAGE 2
6. Tip the backrest cover backward then lay it carefully down on the floor behind the chair. 7. Disconnect the connector at the base of the backrest (Fig.4). 8. Using a Phillips-head screwdriver, disconnect the green-and-yellow ground wire from the chair frame (Fig.4). 9. Remove the backrest cover. Disconnect the green-and-yellow ground wire Connector Backrest cover (Fig.
PAGE 3
INSTALLING THE NEW BACKREST COVER 1. Place the new backrest cover on the floor behind the chair. 2. Connect the large connector. 3. Align the end of the yellow-and-green ground wire with the corresponding hole in the chair frame, then replace the screw to secure it. 4. Thread the remote control cables from the backrest through the backrest cover, so that they are accessible after the backrest cover is installed. 5. Place the backrest cover into position, aligning the four screw holes. 6.