User Manual

PARA/FLEX INSTALLATION HARDWARE

MOUNTING OPTIONS

Beam Mount

Slatwall Mount

Desk Mount

Beam Mount

2 Thumbscrews

3 Desk Mount Screws

Additional hardware required: Electric drill with ½” drill bit

Desk Mount

Desk Mount Bolt

Beam Mount Bolt

Slatwall Mount

Slatwall Mount Bolt

4 Thumbscrews

FRICTION ADJUSTMENTS

EXPANDING/COLLAPSING CROSSBAR

a. After prolonged use, the Ball

Joint Swivel/Tilt Mechanism

may require increased friction.

This can be achieved by

tightening the 3 Ball Joint

Friction Screws (A) using Hex

Key C.

a. Unfold Crossbar Wings to accommodate 3 or 4 monitors per row.

b. Fold away Crossbar Wings to hide behind 1 or 2 monitors.

www.humanscale.com

Hex Key A (8mm)

Hex Key C (4mm)

Hex Key D (2mm)

Vertical Assembly CapCrossbar Cap Vertical Assembly

Flat Bearing

Hand Crank

Hex Key B (5mm)

HSIPM00911

Para/Flex

Instructions

PAGE 1
FRICTION ADJUSTMENTS A Hex Key C (4mm) Hex Key B (5mm) Crossbar Cap Hex Key A (8mm) a. After prolonged use, the Ball Joint Swivel/Tilt Mechanism may require increased friction. This can be achieved by tightening the 3 Ball Joint Friction Screws (A) using Hex Key C. PARA/FLEX INSTALLATION HARDWARE Vertical Assembly Cap Hex Key D (2mm) Vertical Assembly Flat Bearing Hand Crank EXPANDING/COLLAPSING CROSSBAR MOUNTING OPTIONS a. Unfold Crossbar Wings to accommodate 3 or 4 monitors per row.
PAGE 2
STEP 1: ATTACH MOUNT TO WORK SURFACE Slatwall Mount Beam Mount C a. Slide Vertical Assembly (A) into Slatwall Mount (B) as shown. A a. Slide Vertical Assembly (A) into Beam Mount (B) as shown. A b. Fasten Slatwall Mount Bolt (C) into the underside of Slatwall Mount using Hex Key A. B b. Fasten Beam Mount Bolt (C) into the underside of Beam Mount using Hex Key A. B C B a. Attach Hand Crank (A), as shown. e. Snap in provided Caps (G) to cover large clamp screw hole (F). F D c.