Operation Manual
Erase the last dialed numbers
1. By pressing the key , the last dialed
number will be displayed.
2. Using , you can dial the last dialed num-
bers.
3. Press "More" and select "Erase" to erase
this entry or "Erase all" to erase all en-
tries. Press "Select" to complete this pro-
cess.
Adjusting the receiver volume/high/low
frequencies
The receiver volume can be adjusted during
a calls by using the or keys, which
are located on the left side of the phone.
The key can be used to switch an ad-
ditionalamplicationon.A volume of up to
30 dB is achieved if the additional ampli-
cationisswitchedon.Theredamplication
display on top of the phone is illuminated if
theamplicationhasbeenswitchedon.The
additional amplication will be switched off
by pressing the key again.
You can adjust the volume with .
Press the key and adjust the desired
volume from 1 to 3.
Note:
The volume control can only be adjusted
during a call.
Use of the phone with a hearing aid
You can use your phone with hearing aids,
assumed they are equipped with a T-coil.
For this purpose. place the selector switch
at your hearing aid to the "T" or "MT" po-
sition. Please ensure that the telephone re-
ceiver will be placed as close as possible to
your hearing aid during a phone call.
Muting
You can switch the microphone of your
phone temporarily off during a call, which
means that your conversational partner can
no longer hear you.
"Mute" will be displayed in the lower right
screen area of the display during a call. The
mute function will be activated when press-
ing the right function key. The function will
be deactivated when pressing the key again.
Call back key
This function is required to activate certain
T-NET performance features.
"R" will be displayed in the lower left screen
area of the display during a call. By press-
ing the left function key, the phone line will
be disconnected for a certain time (100ms/
120ms/ 300ms/ 600ms) (see "Setup of the
call back time).
Finding a mobile unit
In case you misplaced the mobile unit, you
can nd it by using the mobile unit search
key on the Base.
1. Press the search key on the Base
briey. The registered mobile units start
ringing for app. 50 seconds.
2. Press the search key once more to
stop the search process.
English 29