Operation Guide

The information and specifications included are subject to change without notice.

BGW320-500 XGS-PON Broadband Gateway Release 1.0

Install and Operation Guide

3-1. Connecting the Power Adapter

The power adapter supplies power to the BGW320-500 XGS-PON Broadband Gateway.

1. Connect the appropriate end of the power adapter cable to the BGW320-500 XGS-PON

Broadband Gateway rear panel POWER port.

2. Connect the power plug end to the electrical outlet.

After the BGW320-500 XGS-PON Broadband Gateway is powered on, the power light blinks white.

For all power light indications, see Status Indicator Lights (page 18, 19, 20) under Basic

Troubleshooting.

Warning: Use only the power supply and cord that came with the BGW320-500 XGS-PON Broadband

Gateway. Failure to use the authorized power supply and cord may cause electric shock, fire, bodily

injury, and/or property damage. If the power supply or cord becomes damaged or needs to be

replaced, to obtain an authorized replacement please contact AT&T customer service by phone

(1.800.288.2020) or via website (www.att.com/support).

3-2. Connecting Computers to the BGW320-500 XGS-PON

Broadband Gateway

The first computer you connect can be used to configure the BGW320-500 XGS-PON Broadband

Gateway settings. You can connect more computers and other devices to the BGW320-500 XGS-PON

Broadband Gateway using wireless or wired Ethernet.

3-2-1. Connecting Devices Using Wired Ethernet

The BGW320-500 XGS-PON Broadband Gateway has four wired Ethernet ports (three 1Gbps Ethernet

ports and one 5Gbps Ethernet port) that can be used to connect computers or other devices.

As shown in the illustration below, to connect a computer to the BGW320-500 XGS-PON Broadband

Gateway:

1. Connect one end of the Ethernet cable to one of the Ethernet ports on the BGW320-500 XGS-

PON Broadband Gateway.

2. Connect the other end of the cable to the Ethernet port on the computer.

Note: To use 5Gbps Ethernet port, recommended to connect with CAT-7 Ethernet cable.