Operation Guide

14
© Copyright 2019 HUMAX. All rights reserved.
The information and specifications included are subject to change without notice.
 The PUSH method establishes Wi-Fi connectivity if you push the WPS button on the front panel of
the BGW320-500 XGS-PON Broadband Gateway and on the Wi-Fi device.
 Upon WPS button push, the WPS button light green slow flash and turn to steady green once WPS
is completed successfully.
 See Status Indicator Lights (page 18,19,20) under Basic Troubleshooting for all WPS indications.
3-3. Connecting the BGW320-500 XGS-PON Broadband Gateway
to the Internet
Note: The appropriate port to connect to the Internet is based on the service configuration from
AT&T. Do not change the port used unless instructed to do so.
Warning:DO NOT REMOVE THE OPTIC MODULE AFTER INITIAL INSTALLATION WITHOUT ANY
INSTRUCTION FROM AT&T.
Only one of these wiring arrangements can be used at the same time and attempting to use both
may interfere with your service.
The optic module port which completed for installation can be used to connect the BGW320-500
XGS-PON Broadband Gateway to the Internet:
1. Connect one end of the fiber cable to the optic module port on the BGW320-500 XGS-PON
Broadband Gateway.
2. Connect the other end of the fiber cable to the wall outlet.
After the BGW320-500 XGS-PON Broadband Gateway recognizes the connection, the service LED will
light steady white. See Status Indicator Lights (page 18, 19, 20) under Basic Troubleshooting for all
Broadband light indications.
Fiber Cable
Fiber Outlet
Optic Module
BGW320-500 XGS-PON Broadband Gateway Release 1.0
Install and Operation Guide