Operation Guide

19
© Copyright 2019 HUMAX. All rights reserved.
The information and specifications included are subject to change without notice.
BGW320-500 XGS-PON Broadband Gateway Release 1.0
Install and Operation Guide
Conditions for LED
Behavior
S ervice LED WPS LED
Power
Jack LED
Ethernet &
O NT LED
Notes & Light mean
Device is
overheated
S olid Red O ff
S olid
Green
So lid Green if
connected
device
 Device is over heated.
 Unit is in a location that is causing it to overheat. It needs to be on a
flat surface in which there is sufficient space around, under and
above the unit for air to cool the unit.
Phone registration
F a ilure
Yellow/
F a st Flash
Current
S etting
S olid
Green
So lid Green if
connected
device
 VoIP lines are not able to register. One of VoIP lines is having a
problem.
Phone Registration
S ucceeds
S olid White
Current
S etting
S olid
Green
So lid Green if
connected
device
 At least one VoIP line has been configured and all configured VoIP
lines are registered with a SIP proxy server.
V oIP Available – No
Ca lls in Progress
S olid White
Current
S etting
S olid
Green
So lid Green if
connected
device
 No phone off-hook or ringing. Behavior to be consistent with current
U-verse RG's.
V oIP Available –
Phone Off-Hook or
Ringing
S olid White
Current
S etting
S olid
Green
So lid Green if
connected
device
 Ready for any Phone Off-Hook or Ringing.
S oftware Image
Upgrade and
Downgrade in
progress
O range/
S low Flash
Current
S etting
S olid
Green
So lid Green if
connected
device
 Flashes orange for 3-4 seconds during the programming of image to
the flash. The LED pattern for downgrade is the same as upgrade.
During WPS attempt
for user managed
(e.g. data) SSIDs
Current
S etting
Green/
S low
Flash
S olid
Green
So lid Green if
connected
device
 When WPS Button pushed. 2 minutes of Green Flash.
 The WPS button has been pressed on the RG and is awaiting the user
to walk over to the device to be connected and take action on that
device (e.g., press its WPS button).
S ession overlap
detected during
WPS attempt
Current
S etting
RED/
Fa st
Flash
S olid
Green
So lid Green if
connected
device
 Session overlap detected during WPS attempt.
 The device has detected multiple devices attempting to connect.
Must wait 2 minutes before trying to connect again.
F a ilure detected
during or by end of
WPS attempt
Current
S etting
S olid RED
S olid
Green
So lid Green if
connected
device
 There was an error in attempting to connect devices using WPS.
(WPS disabled for all associated radios or SSIDs, all associated radios
are disabled, protocol prematurely aborted, failure to find any
partner after attempt period) 5 minutes for Solid Green.
S uccess following
WPS attempt
Current
S etting
S olid
Green
S olid
Green
So lid Green if
connected
device
 WPS completed successfully. 5 minutes for Solid Green.