Operation Guide

22
© Copyright 2019 HUMAX. All rights reserved.
The information and specifications included are subject to change without notice.
BGW320-500 XGS-PON Broadband Gateway Release 1.0
Install and Operation Guide
4-3. Rear Panel Connectors
Connectors on the rear panel are depicted below.
BGW320-500 XGS-PON Broadband Gateway Rear Panel
ONT Port
1Gbps Ethernet Ports (#2 ~ #4)
5Gbps Ethernet Port (#1)
USB 2.0 Port
SFP/SFP+ Cage for Optic Module
Power Jack
Phone Line
Reset Button
Note: The BGW320-500 XGS-PON Broadband Gateway supports two voice lines
over one RJ14 (FXS) analog port. To connect two phone lines, an inner and outer
pair splitter adapter must be attached to the RJ14 (FXS) analog port to terminate
both lines.
Note: The BGW320-500 XGS-PON Broadband Gateway supports one SFP/SFP+
Cage. To install Optic Module into SFP/SFP+ Cage, follow the guidance from AT&T.
Warning:DO NOT REMOVE THE OPTIC MODULE AFTER INITIAL INSTALLATION
WITHOUT ANY INSTRUCTION FROM AT&T.