Operation Guide

23
© Copyright 2019 HUMAX. All rights reserved.
The information and specifications included are subject to change without notice.
BGW320-500 XGS-PON Broadband Gateway Release 1.0
Install and Operation Guide
4-4. Factory Reset Switch
The Reset switch will result in a reboot of the BGW320-500 XGS-PON Broadband Gateway. Depending
on the software loaded on the BGW320-500 XGS-PON Broadband Gateway, holding it for an
elongated duration of time may reset the device to factory defaults.
 Referring to the diagram below, find the round Reset switch opening.
BGW320-500 XGS-PON Broadband Gateway Rear Panel
Reset Button
 Press the reset button to initiate the following:
 Press the reset button for less than 10 seconds to standard reboot the BGW320-500 XGS-PON
Broadband Gateway, the Service LED on the front panel will respond immediately and lights
red flash within 10 second of the reset button being pressed.
 The service LED will lights fast flash red during the button is still being pressed and turns
steady white once the reset button released within 10 seconds.
 If the reset button is held for more than 10 seconds, it will start to factory reset.
 Press the reset button and hold for longer than 10 seconds, to reset the device to the factory
default shipped settings. If the button is held for ten seconds, the service LED will start to
blink white flash and WPS LED will start to blink green flash.
 If the reset button is held more than 15 seconds, service LED will turn on steady white and
WPS LED will be turned off, and start to factory reset.
Warning: Resetting the BGW320-500 XGS-PON Broadband Gateway to factory defaults will require all
configured settings to be reconfigured.