Operation Guide

26
© Copyright 2019 HUMAX. All rights reserved.
The information and specifications included are subject to change without notice.
BGW320-500 XGS-PON Broadband Gateway Release 1.0
Install and Operation Guide
CHAPTER 6
6. Important Safety Instructions
Warning: Do not use before reading these instructions.
Do not connect the Broadband Ethernet port (labeled ONT) to a carrier or carriage service provider’s
telecommunications network or facility unless:
A) You have the written consent of the network or facility manager, or
B)The connection is in accordance with a connection permit or connection rules.
Connection of the Ethernet ports may cause a hazard or damage to the telecommunication network
or facility, or persons, with consequential liability for substantial compensation.
6-1. WARNINGS
The power supply must be connected to an outlet. Do not defeat the protective earth connection.
The direct plug-in power supply serves as the main power disconnect; locate the direct plug-in power
supply near the product for easy access.
6-2. Product Ventilation
The gateway is intended for residential use. Position the gateway in an upright vertical position and
locate it where temperatures remain within a range of 32° – 107°F (0° – 41.7°C) and where heat
from the unit itself is not trapped. There must be at least two inches (2") of clearance on all sides
except the bottom.
6-3. Telecommunication Installation Cautions
 Never install telephone wiring during a lightning storm.
 Never install telephone jacks in wet locations unless the jack is specifically designed for wet
locations.
 Never touch uninsulated telephone wires or terminals unless the telephone line has been
disconnected at the network interface.
 Use caution when installing or modifying telephone lines.
 Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a
remote risk of electric shock from lightning.
 Do not use the telephone to report a gas leak in the vicinity of the leak.