Operation Guide

The information and specifications included are subject to change without notice.

BGW320-500 XGS-PON Broadband Gateway Release 1.0

Install and Operation Guide

6-7. IEC Symbol Descriptions

Caution:IEC symbols are marked at bottom label of the BGW320-500 XGS-PON Broadband Gateway.

Product usage must be followed with IEC guidance.

6-8. FCC Compliance Statement

Symbol Title/Meaning/Referent Reference Number Function/Description

• Class II equipment • IEC 60417-5172

• To identify equipment meeting the safety

requirements specified for Class II equipment

according to IEC 61140.

• Double insulated Class II equipment (IEC 60417-5172).

• Do not require an earth connection.

• For indoor use only • IEC 60417-5957

• To identify electrical equipment designed primarily for

indoor use.

• Direct current • IEC 60417-5031

• To indicate on the rating plate that the equipment is

suitable for direct current only; to identify relevant

terminals.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following

measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

—Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications not expressly approved by the party responsible for

compliance could void the user’s authority to operate this equipment. This transmitter must not be

co-located or operating in conjunction with any other antenna or transmitter.

6-9. FCC Caution

6-10. Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits as set forth for an uncontrolled

environment. This equipment should be installed and operated maintaining a minimum distance of

31 cm (12 inches) between the device and your body.