Operation Guide

7
© Copyright 2019 HUMAX. All rights reserved.
The information and specifications included are subject to change without notice.
CHAPTER 2
2. Preliminary Safety Instructions
Warning: Do not use before reading these instructions.
Do not connect the Ethernet ports to a carrier or carriage service provider’s telecommunications
network or facility unless:
 You have the written consent of the network or facility manager, or
 The connection is in accordance with a connection permit or connection rules.
Connection of the Ethernet ports may cause a hazard or damage to the telecommunication network
or facility, or persons, with consequential liability for substantial compensation.
2-1. Power Supply Installation
Connect the power supply cord to the power jack on the BGW320-500 XGS-PON Broadband Gateway.
Plug the power supply into an appropriate electrical outlet.
Warning: The power supply must be connected to a mains outlet with a protective earth connection.
Do not defeat the protective earth connection.
Warning: Use only the power supply and cord that came with the BGW320-500 XGS-PON Broadband
Gateway. Failure to use the authorized power supply and cord may cause electric shock, fire, bodily
injury, and/or property damage. If the power supply or cord becomes damaged or needs to be
replaced, to obtain an authorized replacement please contact AT&T customer service by phone
(1.800.288.2020) or via website (www.att.com/support).
Caution:Depending on the power supply provided with the product, either the direct plug-in power
supply blades, power supply cord plug or the appliance coupler serves as the mains power
disconnect. It is important that the direct plug-in power supply, socket-outlet or appliance coupler be
located so it is readily accessible.
BGW320-500 XGS-PON Broadband Gateway Release 1.0
Install and Operation Guide