User's Manual

8. Installation

⑥ Confirm S ignal Strength and Quality Level and fine-

tune the Antenna direction.

1 Select

Go to Stored Position using the ▲ ▼ button.

2 Move the Antenna to East/West by pressing

<RIGHT>/<LEF T> button. Adjust Signal Level to

maximum/

⑦ Save the adjusted position of Satellite.

1 Select S tore C urrent Position using the ▲ ▼ button.

2 Press the <OK> button to save the Antenna position

headed for the selected Satellite.

⑧ You can set antenna position by satellite by repeating

the above procedure.

⑨ You can recalculate positions for all other satellite

based on one satellite. Adjust position of antenna by

satellite based on one set position without setting

each position of antenna by satellite.

1 Select Recalculation using the ▲ ▼ button.

2 Press the <OK> button.

3 To adjust all positions again, select Yes and press

the <OK> button.

[ Note] You cannot perform ~  steps in case of USALS Motor

(4) Installer Menu

You can set default setting and operation limit for Motor Antenna.

① Select

Installer Menu from Motor Antenna Menu using the ▲ ▼ button.

② Press the <OK> button to move to Installer Menu.

Motor Limit Setting

You can set the maximum Motor Limit both East and West to prevent damage to the antenna.