Operation Manual

GB16
User’s Manual
2. Connections
This chapter describes how to connect your product to the TV with the particular equipments for gaining
optimum signal quality. The product provides various interfaces to connect to the TV, VCR or other
devices. Select the most appropriate procedure depending on the equipment you have.
Note: If you encounter any problems setting up your product, please contact your local retailer or Humax
Customer Helpline.
2.1 Connecting the Antenna
You can select one of the following antenna connections depending on the equipment you have. The
product has two antenna modes according to setting.
Change this to the  rst option.
1. Connecting Two Satellite Cables
Connect the two cables from your satellite dish to the LNB 1 IN and
LNB 2 IN connections on the rear of the product.
Note: To maximize the use of all PVR features FOXSAT-
HDR provides, connecting with two cables from
the same satellite dish is strongly recommended.
This will allow you to:
• View and record di erent channels
• Record two channels at the same time
2. Single Cable Using Loop Through
1. Connect the cable from your satellite dish to LNB 1.
2. Connect a cable from the LNB 1 OUT to the LNB 2 IN connection.
Note:
• If connecting with a single cable using loop through, you will
have limited functionality.
While recording a channel you will be limited to the second
channel you can view.
Visit www.humaxdigital.com/freesat for further information.
• When using a Motorised System, SCD Antenna (also known as
Unicable), or SMATV please connect the cable to LNB 1.
ASTRA 1 19.2E
Twin LNB
ASTRA 1 19.2E
Single LNB