User`s manual

English

Quick Start Guide

Connecting the Network

ݎConnecting to the LAN;

Connect one end of the Ethernet cable to the recorder and the other end to the LAN router.

ݏConnecting to the Wi-Fi (Wireless LAN);

You can connect the network via the Wi-Fi access point or DSL/cable modem.

1. Plug in the wireless USB dongle to the USB port.

2. Set the options for the Wi-Fi.

 Network Name (SSID): Select the network name of your Wi-Fi access point from the list.

 Security Type (WEP): This product supports WEP 40/128bit ASCII and WEP 40/128bit HEX. The security type of

the Wi-Fi and the receiver shall be set the same.

 Password: When using the security type, you must set the password. Enter the same password in the Wi-Fi

setting menu.

3. After completing the Wi-Fi access point setting, make sure the settings in Installation Wizard or

System>Network>Con gure Wi-Fi are the same.

Note:

• Make sure the distance between the Wi-Fi access point and the receiver is not too far away. This may

lower the quality of service.

• It is recommended to purchase a wireless USB dongle distributed by HUMAX. Other products may not

function or respond.

ݐUsing HUMAX Powerline AV Adaptor;

You can connect to the network using the HUMAX Powerline AV Adaptor. Connect one end of the Ethernet

cable to the recorder and the other end to the adaptor. Plug the HUMAX Powerline AV Adaptor to a wall

outlet. (Separate purchase required)

Note: HUMAX recommends the network connection over a direct LAN or the HUMAX powerline

AV adaptor.

LAN

Ethernet Cable

RouterWireless Router

USB