User's Manual

[ Getting Started ]

Once the antenna cable is routed through the vehicle, and you are satisfied with the cable

routing, peel the protective material from the adhesive strip and press the rubber antenna

cable cover/tail firmly into place on the vehicle. Double check that the location of the antenna

and rubber antenna cable cover/tail are correct, and continue to press firmly down on rub-

ber antenna cable cover/tail for another 30 seconds. (Figure 4) At room temperature (68

degrees), maximum adhesion usually occurs within 72 hours. During this period, avoid car

washes and other contact with the antenna and rubber antenna cable cover/tail.

Figure 4Figure 4

Installing the Battery

The battery is fully charged and ready to use. To install the battery, simply remove the protec-

tive material as shown in figure 1.

To install the battery in the remote control, refer to Figure 1.

Illustration depicting how to

enable the batteries

Sirius S50 & Remote Control.

Figure 1Figure 1