User Manual

2
Table of Contents Page
1.0 Introduction 3
2.0 Setup 4
3.0 Set Value Control 6
4.0 Operational Modes 6
4.1 Changing Operational Modes 7
4.1.1 Normal Mode 7
4.1.2 Standby Mode 8
4.1.3 Ramp/Soak Cycle Mode 8
5.0 Changing Ramp/Soak Cycle Settings 9
5.1 Setting Recipe Options 9
5.2 Setting Holdback Band 10
5.3 Setting Termination State 10
5.4 Setting Number of Cycles 11
5.5 Setting Power Fail-Resume Options 11
5.6 Setting Ramp Times 12
5.7 Setting Soak Temperatures 12
5.8 Setting Soak Time 13
6.0 Service 13