User Manual

5
4) Plug the main power cord from the controller box into an appropriate
receptacle. The controller requires a 125VAC, 30 amp power source.
5) Connect the thermocouple wire from the machine to the matching
connector coming from under the chart recorder.
6) The main circuit breaker is located on the side of the controller box near the
door latches. Set the breaker to the ON position.
7) Wait for the controller to go through its self test. When the self test
is complete, the upper red display and the lower green display will show
temperature readings. The green display is the set value and the red display
is the actual temperature reading from the TC (Figure 4).