Owner's manual

product manual

09.09

H-3620, H-3624, H-3625

Flow Table

with Mold

PAGE 1
09.
PAGE 2
PAGE 3
Introduction These Flow Tables are constructed in accordance with the current ASTM Specification C 230, using the inch-pound units for the tables, and for accessory sets of molds and calipers, both inch-pound and metric (SI) units. Models Shipping Wt. H-3624 Flow Table, Motorized, with automatic counter (110V, 60Hz) H-3624.5F, same H-3624 except (220VAC, 50 Hz, 1 ph) H-3625 Flow Table, Motorized (110V, 60Hz) H-3625.5F, same as H-3625 except (220 VAC, 50 Hz, 1 ph) H-3620 Flow Table, Hand driven 108 lbs.
PAGE 4
When the concrete is cured insert the proper ½ " (13mm) padding or pads under the pedestal. After mounting, tighten all fasteners (20 ft. lb. torque or 27 NM) and check to see the able top is level along two diameters in both the raised and lowered positions. Operation Depending upon the model purchased operation are the following: 1. By hand (cranking clockwise). 2. By actuating the switch (on the motor line-cord) to the desired count or 3. By presetting and actuating the automatic counter.
PAGE 5
H-3620
PAGE 6
H-3624
PAGE 7
H-3625
PAGE 8
Warranty Humboldt Mfg. Co. warrants its products to be free from defects in material or workmanship. The exclusive remedy for this warranty is Humboldt Mfg. Co., factory replacement of any part or parts of such product, for the warranty of this product please refer to Humboldt Mfg. Co. catalog on Terms and Conditions of Sale. The purchaser is responsible for the transportation charges. Humboldt Mfg. Co.