08.
General The H-4150 and H-4150.4F motorized sample ejectors are designed to remove samples from molds and tubes. They feature a 5-ton capacity motorized hydraulic pump and ram assembly and incorporate extended upright rods in order to accommodate both standard 4” or 6” asphalt compaction molds, as well as the taller gyratory compaction molds. Overall dimensions excluding pump 13” W x 6” D x 29” H (330 x 152 x 737mm). The Model H-4150 consists of the following main components: 1.1 H-4150.2 - Pump Assembly. 1.
Operation Place and attach the proper size ejection disc for the mold or tube onto the jack piston rod and insert the matching ejection ring into the top casting using the key notches to retain it by twisting approximately 30 degrees. Place the mold with sample into the disk and raise the jack to bring the mold into engagement with the top ring. Continue applying force by operating the jack handle to push the sample from the mold.
Warranty Humboldt Mfg. Co. warrants its products to be free from defects in material or workmanship. The exclusive remedy for this warranty is Humboldt Mfg. Co., factory replacement of any part or parts of such product, for the warranty of this product please refer to Humboldt Mfg. Co. catalog on Terms and Conditions of Sale. The purchaser is responsible for the transportation charges. Humboldt Mfg. Co.
