Manual

19
Press
(SENSORMAX)tomovebetweenthenumbers.Keeppressing
untilthedigityouwanttochangeisashing.Onceyouhave
selected the number you want to change, press (INCREASE)or
(DECREASE) to change the number to the desired value. Below is a
configuration chart for Humboldt instrumentation. These are the numbers
that correspond to each Humboldt sensors.
Load Cell Part# English Max (lbf) Metric Max (kN)
10,000 lb. (50kN) HM-2300.100 010000 050.00
5,000 lb. (25kN) HM-2300.050 005000 025.00
2,000 lb. (10kN) HM-2300.020 2000.0 10.000
1,000 lb. (5kN) HM-2300.010 1000.0 05.000
500 lb. (2.5kN) HM-2300.005 0500.0 02.500
LVDT Transducer Part# English Max (in.) Metric Max (mm)
0.4" (10.0mm) HM-2310.04 0.4000 10.000
1.0" (25.4mm) HM-2310.10 01.000 25.000
2.0" (50.8mm) HM-2310.20 02.000 50.000
Pore Pressure Part# English Max (psi) Metric Max (kPa)
100psi (1000kPa) HM-2300.100 0100.0 001000
To return to any prior screen you can always press
Channel Test Configuration
In order to perform a test, channels must be configured for the specific test
you wish to run. To configure a channel for a test, press You should
see this screen:
Press
you will see this screen:
* REVIEW LAST TEST
* RUN TEST
* MORE SETUP
* ENGINEERING SETUP
* SENSOR LIMITS OFF
* RAW_DATA
* MORE SETUP