Manual

26
NOTE:Ifyouapplyallthesurchargeweightinthemoldatthebeginning
ofthetest,justPress
to continue. The HM-3000 will start the test.
The display will show the current reading of the load and displacement.
The HM-3000 will collect a load reading every 0.025 inches. Once the
displacement reaches 0.5 inches, the machine will stop collecting data
and reverse the platen back to the lower limit at 2.0 in/min (50.8 mm/min).
At any time you can press
to end the test. This will stop the data
collection and reverse the platen to its down position. You should see this
screen:
Pressing (PRINTDATA)willprintthedatatoaprinterorsaveale
in ASCII mode to your computer using Humboldt Material Testing Software
(HMTS)orWindowsHyperterminal.Oncethedatahasbeenprintedor
transferred, you can begin another test after you have readied a test mold on
the platen by pressing
(RUNCBR/LBRTEST).
If you don’t have a printer or a computer connected to the HM-3000, you
can press
(SCROLL DATA) to scroll the data. You should see this
screen:
Using the
(NEXT)keytoscrollthroughthereadingsandthe
(LAST) key to view the last reading taken.
To return to any prior screen you can always press
Marshall
Centerthebreakingheadontheplaten.Pressthe
button to raise the
head to the start position, close to the load cell. There should be about
a 1/8" (3.000mm) gap between the breaking head and the load cell.
Press You should see this screen:
* PRINT DATA
* SCROLL DATA
* RUN CBR/LBR TEST
LOAD “READING”
PENETRATION “READING”
* NEXT
* LAST READING #