Manual

27
Press
(RUNTEST)Youshouldseethisscreen:
Press (MARSHALL TEST) This will automatically start the platen to
rise at a rate of 2.0 in/min (50.8mm/min). You should see this screen:
The display above will give constant real-time readings of the stability and
owmeasurementsduringthetestcycle.Youcanendthetestatanytime
by pressing
. This will stop all data collection and reverse the platen
to its down position.
As the breaking head makes contact with the load cell, the HM-3000
willautomaticallyzerothestabilityandowreadingsandbegintotakes
readings every 0.1 seconds. Once the test has reached peak stability (i.e.
peak load) and fallen back 2%, data will cease being collected and the platen
will begin to reverse and move back to the down position. As the platen
moves down, the screen will display the peak values.
You should see this screen:
* REVIEW LAST TEST
* RUN TEST
* MORE SETUP
* MARSHALL TEST
* CBR/LBR TEST
* USER DEFINED TEST
MARSHALL TEST # of readings
STAB “#”
FLOW “#”
* END TEST
STAB PEAK “#”
FLOW PEAK “#”
REVIEW DATA
* RUN MARSHALL TEST