Manual

29
Press
You should see this screen:
Press (RUNTEST)Youshouldseethisscreen:
Press
(USERDEFINEDTEST).Youshouldseethisscreen:
Press (SPEED)toaccessthespeedreadoutonline2ofthescreen
above.Keeppressing untilthedigityouwanttosetisashing.Once
you have selected the digit you wish to set, press to increase the
number or press to decrease the number. Once the speed has been
set, press
to initiate the test. You should see this screen:
The display above will give constant real-time readings of the load and
displacement measurements during the test cycle. You can end the test at
any time by pressing
. This will stop all data collection and reverse
the platen to its down position.
Once the sample makes contact with the unconfined upper platen the
HM-3000 will automatically zero the load and displacement readings and
collectaloadreadingevery“X”second,dependingonwhatlogginginterval
has been set (see logging interval).
* REVIEW LAST TEST
* RUN TEST
* MORE SETUP
* MARSHALL TEST
* CBR/LBR TEST
* USER DEFINED TEST
MOTOR SPEED ADJUST
* SPEED = “X.XXXX”
* INCREASE
* DECREASE
LOAD 1 VALUE
DISP 1 VALUE
* END TEST #1