Owner's Manual

6. Adjust the transducer assembly vertically,

until the seam on the leading edge of the

transducer (the edge closest to the transom of

the boat) is level and just slightly below the

hull (Figure 23).

NOTE: The transducer has a natural downward slant of 4-5

degrees from leading edge (closest to the boat transom) to

trailing edge (farthest away from the boat). Looking at the

back of the transducer, the seam should be slightly below

the bottom of the hull.

7. Continue to adjust until the bracket is also

level from port to starboard (horizontally level

as you look at the transducer from behind the

boat [Figure 24]).

8. Mark the correct position on the transom by

tracing the silhouette of the transducer

mounting bracket with a pencil or marker.

9. Tighten the pivot bolt, using the pivot screw

and nut to lock the assembly. Hand tighten

only!

CAUTION! Do not use a high speed driver on this

combination of fasteners. Hand tighten only.

10. Hand-tighten the two mounting screws.

NOTE: You will drill the third mounting hole and finalize the

installation after you route the cable and test and finish the

installation in the following procedures.

Seam aligned with boat hull

Adjusting the Transducer

Mounting Position

Figure 23

Figure 24

Level

Leveling the Mounting

Assembly Horizontally

Transom Transducer Installation