Use and Care Manual

211
Side Imaging
C
hange the SwitchFire Mode
SwitchFire controls how the sonar returns are displayed in the view.
1. With a Side Imaging View displayed on-screen, tap Sonar (SI) in the status bar, or press the MENU key once.
2. Select SwitchFire.
3. Select Clear Mode or Max Mode.
QUICK TIP! This setting can also be changed in the status bar menu.
Set the Range
Range controls how much of the water column is displayed on the view.
1. With a Side Imaging View displayed on-screen, tap Sonar (SI) in the status bar, or press the MENU key once.
2. Select Range.
3. Tap the slider to select Auto or Man (Manual), or press the ENTER key.
Clear Mode
Choose Clear Mode to see less clutter and more fish size accuracy on the display. When Clear
Mode is selected, the clutter is filtered, and sonar returns are interpreted to provide more
details about the objects within the transducer beam, regardless of their location. In other
words, a large arch on the display means a large fish has been detected.
Max Mode
Choose Max Mode to see only raw sonar returns on the display. When Max Mode is selected,
you will see the maximum sonar information available within the transducer beam, so more
fish arches and better jig tracking are shown.
Auto The Range will be adjusted by the control head to follow the bottom automatically.
Man (Manual)
To adjust the display range, press and hold the slider, or press and hold the ENTER key. Select
a low range number to focus on a shorter distance of the water column and see greater detail
on the screen. Select a higher range number to view farther into the water and see an overview
of details on the screen.