Use and Care Manual

235
Transducer Setup
S
elect and Display Frequencies for the Side Imaging View
(optional, CHIRP MEGA SI and CHIRP MEGA SI+ models only)
Use the instructions in this section to choose a frequency that will be used for the Side Imaging View.
QUICK TIP! You can also select this menu on the status bar and in the X-Press Menu in Side Imaging View.
1. Press the HOME key.
2. Select Settings.
3. Select CHIRP Sonar.
4. Under Side Imaging CHIRP, select SI Frequency Select and Display.
5. Select a frequency.
See the SI Frequency Select and Display Options table below.
Select and Display Frequencies for the Down Imaging View
(optional, CHIRP MEGA DI, MEGA DI+, MEGA SI, and MEGA SI+ models only)
Use the instructions in this section to choose a frequency that will be used for the Down Imaging View. The menu options are
determined by the installed transducer and control head model.
QUICK TIP! You can also select this menu on the status bar and in the X-Press Menu in Down Imaging View.
1 Press the HOME key.
2. Select Settings.
3. Select CHIRP Sonar.
4. Under Down Imaging CHIRP, select DI Frequency Select and Display.
5. Select a frequency.
See the DI Frequency Select and Display Options table.
CHIRP MEGA SI Models
SI Frequency Select and Display Options (CHIRP Off, On)
MEGA+ Select MEGA+ for the highest resolution, sharpness, and range (up to 400 ft side to side).
MEGA Select MEGA for the highest resolution, sharpness, and range (up to 250 ft side to side).
800 kHz Select 800 kHz as an alternative frequency with sharp returns (up to 250 ft side to side).
455 kHz Select 455 kHz for deep water and overall coverage (up to 800 ft side to side).