Use and Care Manual

245
Control Head Configuration
NMEA 0183
Configure the NMEA Talker ID
Use the following instructions to change the NMEA 0183 Talker ID to match the NMEA 0183 installed accessory.
1. Press the HOME key.
2. Select Settings > Network.
3. Under Sensor Port, select a NMEA port menu.
4. Select NMEA Output.
5. Under Configure NMEA Talker ID, select IN-Integrated Navigation (Default) or GP-Global Positioning System.
Message Description Input Output
A
AM
W
aypoint Arrival Alarm
•
APB Heading/Track Controller (Autopilot) Sentence “B”
•
BOD Bearing-Origin to Destination
•
BWC Bearing & Distance to Waypoint - Great Circle
•
BWR Bearing & Distance to Waypoint - Rhumb Line
•
DBT Depth Below Transducer
• •
DPT Depth
• •
GGA Global Positioning System Fix Data
• •
GLL Geographical Position - Latitude/Longitude
• •
GNS GNSS Fix Data
• •
GSA GNSS DOP and Active Satellites
• •
GSV GNSS Satellites In View
• •
HDG Heading, Deviation & Variation
• •
HDM Heading, Magnetic
• •
HDT Heading, True
•
MTW Water Temperature
• •
MWD Wind Direction & Speed
•
MWV Wind Speed & Angle
•
RMB Recommended Minimum Navigation Information
•
RMC Recommended Minimum Specification GNSS Data
• •
ROT Rate of Turn
• •
VBW Dual Ground/Water Speed
•
VDM AIS VHD Data Link (Other Vessels)
•
VDO AIS VHD Data Link (Own Vessel)
•
VHW Water Speed and Heading
• •
VTG Track Made Good & Ground Speed
•
XDR Transducer Measurements
•
XTE Cross-Track Error, Measured
•
ZDA Time & Date
• •