Use and Care Manual

253
NMEA 2000 Setup
Set up Fuel Tanks
The Setup Guide provides prompts to set up the fuel tanks in the system, and it assigns a source number to each fuel tank. If a
NMEA 2000 fuel tank sensor and a fuel flow rate sensor are installed, the control head can display fuel levels automatically. If only
a
fuel flow rate sensor is installed, you need to set up the fuel tanks manually to manage fuel levels.
Set up the Number of Tanks
The number of engines and tanks are entered using the Setup Guide during initial installation. Use the instructions in this section
to change the number of engines and tanks displayed on the control head.
1. Press the HOME key.
2. Select Settings.
3. Select My Vessel.
4. Select Engines/Tanks.
5. Select the total number of engines and fuel tanks on your boat.
If you do not have a NMEA 2000 fuel tank sensor, proceed to Set the Fuel Tank Capacity.
Set the Fuel Tank Capacity
If there is a fuel flow rate sensor installed, but not a NMEA 2000 fuel tank sensor, use the instructions in this section to set up fuel
tank data manually. You can also use these instructions to confirm Automatic Fuel Management Mode if you have a NMEA 2000 fuel
tank sensor and a fuel flow rate sensor installed.
1. Set up the number of fuel tanks on the boat. See Set up the Number of Tanks.
2. Press the HOME key.
3. Select the Fuel tool.
4. Select Settings.
5. Select Manual.
NOTE: If NMEA 2000 fuel tank sensor and a fuel flow rate sensor are installed, select Auto to automatically detect the tank
capacity.
6. Select Fuel Capacity.
7. Use the on-screen keyboard to enter the total fuel capacity of the tank.
If there is more than one tank on the boat, indicate the total amount of fuel from all tanks.
8. Select Save.