Owner's Manual

Connecting Your InterLink™ to the Control Head(s)
Perform the following procedure to connect your InterLink™ to your
Humminbird® Fishing System control heads.
Perform the following installation procedure for your InterLink™ Accessory:
1. Lay out the cables and the InterLink™ to make sure that the cables
will reach both control heads.
2. Interconnect the "To Control Head 1" connector either directly to the
COM port on the control head or to the "Daisy Chain" connector of an
accessory which is already attached to the control head. See the
Accessory System Interconnects diagrams for more information.
NOTE: Several installation scenarios are depicted in the Accessory System
Interconnects graphics on the following pages. Pick the one which best represents
your configuration on your boat. The GPS receiver can be connected directly to the
Interlink™ as shown in Scenario 2, or directly to the control heads as shown in
Scenarios 1 and 3.
CAUTION: It is very important to install the Interlink™ at the end of the daisy chain
of any accessories attached to either control head for data sharing to occur correctly.
InterLink™ Ports
1
2
G
PS
To GPS Receiver
To Control Head 2
To Control Head 1
4
531567-1_D - InterLink_Man.qxp 3/27/2007 3:57 PM Page 4