Fish Finder User's Manual

Routing the Control Head Cables Under the Deck
Use the following steps to route the control head cables under the deck.
NOTE: Under the deck cable routing is not always possible. If this is not an option,
the cables should be routed and secured above deck.
Tilt Mount or Tilt and Swivel Mount:
1a. Mark and drill a 3/4" hole as shown in
Figure 6. Route the cables through the
hole. The cables will exit through the
center hole on the control head base.
1b. If the cables cannot be routed directly
beneath the control head base, mark
and drill a 3/4" hole that will allow you
to run the cables close to the control
head base.
3
/
4
”
1
9
m
m
Figure 6
Tilt Mount or Tilt and Swivel Mount
Control Head Base
NOTE: See the installation section for your transducer type in order to plan the
location of the transducer and cable route.
5
Control Head Installation