Fish Finder User's Manual
Table Of Contents
- Cover
- About this Manual
- Warnings
- Table of Contents
- Installation Overview
- Transducer Installation Overview
- Inside the Hull Transducer Installation
- Trolling Motor Transducer Installation
- Powering ON and OFF
- What You See On the Display
- PiranhaMAX™ Sonar Technology
- The Menu System
- Maintenance
- Troubleshooting
- International Purchases
- Humminbird® 1-Year Limited Warranty
- Humminbird® Service Policy
- Returning Your Unit for Service
- Specifications
- Contact Humminbird®
Attaching the Control Head to the Base
Follow these steps to attach the control head to the already-assembled base:
NOTE: The transducer cable and power cable should be routed prior to securing the
mounting bracket to the deck.
1. Apply marine-grade silicone sealant to the drilled holes for the
mounting bracket.
2. Place the mounting bracket on the mounting surface, aligning with the
drilled holes.
3. Insert the four #8 Phillips countersink wood screws into the mounting
holes and hand tighten only!
4. Insert the thumbknob bolt through the pivot knuckle on the control head
(Figure 7).
5. Align the pivot knuckle with the mount base arms and slide into place,
twisting slightly if necessary, until the unit is firmly seated.
6. Rotate the control head to the desired angle and hand tighten the
thumbknob bolt.
7. Thread the gimbal knob onto the pivot bolt and tighten.
Pivot Knuckle
Gimbal Knob
Thumbknob Bolt
Figure 7
Mounting Holes
6
Control Head Installation