Fish Finder User's Manual

Attaching the Cables to the Control Head
Follow these steps to attach the power and transducer cables to the control head:
1. Matching the cable plugs to the shape
and orientation of the sockets, insert the
transducer and power cables into the
correct sockets on the control head
(Figure 8).
2. With the control head in place, tilt
and/or swivel the unit through its full
range to make sure there is enough
cable slack for the unit to move freely.
Hand tighten the thumbknob bolt when
you achieve the desired position for the
control head.
You are now ready to install the transducer. See Transducer Installation
Overview and then find the section that refers to your transducer type.
Figure 8
Power Temperature Transducer
7
Control Head Installation