Fish Finder User's Manual

6. Adjust the transducer assembly vertically,
until the seam on the leading edge of the
transducer (the edge closest to the transom
of the boat) is level and just slightly below
the hull (Figure 23).
NOTE: The transducer has a natural downward slant
of 4-5 degrees from leading edge (closest to the boat
transom) to trailing edge (farthest away from the
boat). Looking at the back of the transducer, the
seam should be slightly below the bottom of the hull.
7. Continue to adjust until the bracket is also
level from port to starboard (horizontally
level as you look at the transducer from
behind the boat (Figure 24).
8. Mark the correct position on the transom by
tracing the silhouette of the transducer
mounting bracket with a pencil or marker.
9. Tighten the pivot bolt, using the pivot screw
and nut to lock the assembly. Hand tighten
only!
10. Hand-tighten the two mounting screws.
NOTE: You will drill the third mounting hole and
finalize the installation after you route the cable and
test and finish the installation in the following
procedures.
Adjusting the Transducer
Mounting Position
Seam aligned with boat hull
Figure 23
Leveling the Mounting
Assembly Horizontally
Level
Level
Figure 24
15
Transom Transducer Installation