Fish Finder User's Manual
Table Of Contents
- Cover
- About this Manual
- Warnings
- Table of Contents
- Installation Overview
- Transducer Installation Overview
- Inside the Hull Transducer Installation
- Trolling Motor Transducer Installation
- Powering ON and OFF
- What You See On the Display
- PiranhaMAX™ Sonar Technology
- The Menu System
- Maintenance
- Troubleshooting
- International Purchases
- Humminbird® 1-Year Limited Warranty
- Humminbird® Service Policy
- Returning Your Unit for Service
- Specifications
- Contact Humminbird®
Chart Speed
(Setting Saved in Memory)
Press the POWER-MENU key until CHART SPEED appears. Select a setting
from 1-5 to increase or decrease the chart speed, where 1 is the slowest and
5 is the fastest chart speed. Chart speed determines the speed at which the
sonar information moves across the display, and consequently the amount of
detail shown. A faster speed shows more information and is preferred by most
anglers; however, the sonar information moves across the display quickly. A
slower speed keeps the information on the display longer, but the bottom and
fish details become compressed and may be difficult to interpret. (1 to 5,
Default = 5)
Fish Alarm
(Setting Saved in Memory)
Press the POWER-MENU key until FISH ALARM appears. Select Off for no fish
alarm, or one of the following symbols to set the alarm. An alarm will sound
when the PiranhaMAX™ detects fish that correspond to the alarm setting.
Fish Alarm will only sound if Fish ID+™ is also set to On. (Off, Large,
Large/Medium, All, Default = Off)
Depth Alarm
(Setting Saved in Memory)
Press the POWER-MENU key until DEPTH ALARM appears. Select OFF for no
Depth Alarm, or select 3 to 99 feet to set the alarm depth. An audible alarm
sounds when the depth is equal to or less than the setting. (Off, 3 to 99 feet,
Default = Off)
Large fish only
Large/Medium fish only
All fish
32