Installation Instructions
INSTALLATION
16
Dual Roller Shades - Inside/End Mount
The installation brackets are always mounted so that the inner surfaces face each other. The
brackets must be mounted so the shade is level wheninstalled.
■
Center the ordered width -
1
⁄
8
" in the window casement and mark its location.
➤
The minimum depth required for mounting is 3
1
⁄
4
". The fully recessed depth is 5
1
⁄
2
".
■
Place the outside edge of the brackets on the previously made marks and mark each of the
screw holes.
■
Remove the adhesive backing on the wire retainer and place
it to the upper back corner of the motor-side bracket.
IMPORTANT: The front edges of the installation brackets
must be level and aligned to eachother.
■
Use a
1
⁄
8
" drill bit to drill the screw holes.
WARNING: Product is heavy. Mount into wood/metal
studs or into concrete with concrete anchors. Drywall
anchors are not recommended.
■
Check that the mounting surface is level. Shim the brackets if
necessary.
■
Attach the installation brackets using the screws provided.
➤
End Mount Shims Optional. To ensure light gap is even on both sides, you may need
to shim the bracket. Orient the shim as shown. Slide the shim in between the bracket
and window casement. Tighten the screws fully.
Proceed to “STEP 2 — Install the Shade” on page 19.
Wire
Retainer
Shim
(Optional)
End Mount
Inside Mount