Installation Instructions

INSTALLATION
21
■
Dual Roller Shades. Install the front shade (using the
steps on the previous page) in the front of the dual roller
bracket. This shade is a reverse roll shade and should be
oriented as such before installing.
➤
Route the motor cable through the wire retainer to
ensure the cable does interfere with the rear shade.
➤
The front shade is set at the
factory to roll tight when
raised. You can adjust the
top limit to hide the rear
shade roll, if desired. See
“Calibration Reset” on page
27
Cassette Shades
■
Attach the battery wand clip to
the back of the cassette
approximately 10" from the
motor side.
➤
Place the bottom of the clip into the lip, squeeze to compress the clip then rotate
it up and hook it into the top channel.
■
Angle the cassette back and then bring the cassette forward to catch the front lip of
the bracket.
■
Push the cassette back to snap it into the lower lip on the bracket.
Standard Roll
Bottom
Bar
Paper
Banding
Tube and
Shade
Fabric
Reverse Roll
Factory Setting Top Limit Adjusted to
Hide the Rear Shade Roll
Squeeze to
Compress
Clip Installed
Correctly
Bracket
Front
Lip
Cassette Installed