Installation Instructions

OPERATION
28
Resetting Shade Programming
The PowerView
®
App may be used to modify or reset any shade programming to PowerView
Gen 3 remotes, gateways, and scene controllers. Shades may be added to or removed from
Rooms and Scenes in the App at any time. If necessary, shades may also be deleted from the
PowerView App in the Advanced Options section of the Shade Settings menu.
Electronic Limit Adjustments
Electronic limits are set at the factory and normally do not require readjustment. For window
treatments that may need additional adjustment or to set custom limit positions, go to Shade
Settings in the PowerView App for adjustable limits. For more information about setting limits
please visit our website at https://help.hunterdouglas.com/s/powerview-gen-3-manuals.
Adjust Shade Limits (If Necessary)
NOTE: Before adjusting the shade limits, cycle the shade at least twice to the fully open and
closed positions to determine whether limits need adjusting.
Adjusting the Top Limit (Manually)
Standard Bracket, Fascia, Pocket and Dual Roller Shades
■
Raise the shade fully.
■
Disconnect the power and remove the shade. See “Removing the Shade” on page 33.
■
Rotate the shade manually to desired bottom rail position when the shade is fully raised.
■
Verify the top limit screw is screwed in completely. The screw will tighten
counterclockwise for standard roll and clockwise for reverse roll. The top limit screw
shouldn't turn more than one turn to be completely screwed in.
■
Re-install the idle end.
■
With the idle end installed, rotate shade until motor is
aligned to insert into the bracket.
CAUTION: Do not rotate the motor in the tube manually it
will damage the motor.
➤
Standard roll rotate the shade toward the window.
➤
Reverse roll rotate the shade toward the room.
■
Slide the shade up into the bracket until it clicks into place.
Gently pull on shade to ensure it is secure. See “STEP 2 —
Install the Shade” on page 19.
■
Reconnect the power and raise the shade to check new bottom bar position, if good, then
lower shade and adjust bottom limit (if necessary).
■
Check and adjust the bottom limit, as needed. See “Electronic Limit Adjustments” on page
28
.
Top
Limit
Screw
Reverse Roll
Standard Roll