Installation Instructions

OPERATION

Adjusting Hard Top Limit (Cassette)

Attempt a calibration reset first, as explained above. If the bottom rail does not stop at the

desired top limit on its way to the top, you will need to adjust the hard stop top limit.

NOTE: These instructions are for adjusting the hard stop limit for roller shades with Cassette only.

■

Raise the shade fully.

■

Disconnect power and remove the shade from the window. See “Removing the Shade” on

page 33.

■

Gently remove the end cap from the non-control (idle) side of the cassette headrail. The

metal cassette endplate will be exposed with a hole in the middle.

■

Insert a

⁄

" Allen wrench into the hole in the cassette endplate. Turn ¼" clockwise for

standard roll, counterclockwise for reverse role.

NOTE: A ¼" turn raises the upper limit approximately 2" to 3". Reassemble the end cap of the

cassette rail.

■

Re-install the shade in the window. Gently pull on shade to ensure it is secure.

See “STEP 2 — Install the Shade” on page 19.

■

Reconnect the power and raise the shade to check the new raised position for the

bottom bar.

■

Check and adjust the bottom limit, as needed. See “Electronic Limit Adjustments”

on page 28.