Installation Instructions

GETTING STARTED
7
Thank you for purchasing Hunter Douglas Designer Roller and Screen Shades with
PowerView
®
Gen 3 Automation. With proper installation, operation, and care, your new
shades will provide years of beauty and performance.
Please thoroughly review this instruction booklet and the enclosed packing list before
beginning the installation.
Tools and Fasteners Needed
■
Flat blade and Phillips screwdrivers
■
Level (laser level is recommended)
■
Measuring tape and pencil
■
Standard M and Cassette shades. Power drill,
3
∕
32
" drill bit and a
1
∕ 4 " hex driver.
■
Standard L, Fascia and Dual Roller shades. Power drill,
1
∕
8
" drill bit, and
5
∕
16
"
hex driver.
In addition, you will need fasteners designed to work with your specific mounting surface(s).
Standard Shades
■
Standard M shades. #6 hex head screws (provided). Two 1
1
⁄ 2 " screws are provided per
installation bracket.
■
Standard L shades. #10 hex head screws (provided). Two 1
1
⁄ 2 " screws are provided per
installation bracket.
Cassette Shades
■
Wall mount with attached battery wand. Use the cassette spacer blocks with the
#6 x 2" screws provided.
■
Wall mount with satellite battery pack. If using without cassette spacer blocks, use
the #6 x 1
1
⁄ 2 " screws provided.
■
Ceiling mount. Use the #6 x 1
1
⁄ 2 " screws provided.
Fascia and Dual Roller Shades
■
#10 x 1
1
⁄ 2 " Phillips hex head screws (provided). 1
1
⁄ 2 " screws are provided - four
screws for fascia.
Pocket Shades
■
#10 hex head screws (not provided). For additional information regarding the number
of screws needed, see “Pocket Shades” on page 18.