User's Manual

• When programming is completed, briefly press the Program button on the back
of the remote control. The LED on the front should stop blinking, indicating that
you are back in normal operating mode.
• Clearing All Group Programming
o To clear all of the group programming that has been done with a remote
control, you must press the Reset button on the back of the remote for 10
seconds.
o To access this button, remove the battery cover and press the recessed
button with the end of a paperclip or a pushpin.
o Upon clearing the entire group programming, none of the window
coverings will respond to Group Mode commands until they have been
added to a group.
o Even with the group programming cleared, the window coverings are still
fully functional in the Individual Mode.
This device complies with part 15 of the
FCC Rules. Operation is subject to the following
two conditions: (1) This device may
not cause harmful interference, and (2) this
device must accept any interference received,
including interference that may
cause undesired operation.
Do NOT make changes or modifications to this equipment.
Changes or modifications not expressly approved by the
manufacturer may degrade performance, void user’s authority
to operate this equipment, and void manufacturer’s warranty.
Rev1.1